1981 Mercedes-benz Sl

All direction indicators not working (4.4.1 (a) (ii))

Emissions unable to be completed Idle speed too high (8.2.1.2 (d))

Front Headlamp aim projected beam image is obviously incorrect Both images are very poor (4.1.2 (c))

Front Windscreen wiper missing Both (3.4 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Road wheel fixing missing One wheel bolt missing (5.2.1 (a) (i))

Offside Front Track rod end ball joint dust cover insecure so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Rear fog lamp not working (4.5.1 (a) (ii))

Rear fog lamp tell-tale not working (4.9.1 (a) (ii))

Windscreen washer not working All (3.5 (a))

Nearside Front Electrical wiring likely to touch hot or rotating parts Pad wear wire (4.11 (a) (iii)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Exhaust system is very corroded

Front Brake disc worn, pitted or scored, but not seriously weakened Corroded on edges (1.1.14 (a) (ii))

Front Lower Suspension arm corroded but not seriously weakened Both sides (5.3.3 (b) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Sub-frame pin or bush worn but not resulting in excessive movement Bushes both sides are soft and perishing (5.3.4 (a) (i))

Fuel cap seal is perishing

Rear Exhaust mounting defective (6.1.2 (a))

Rear Suspension component mounting prescribed area is corroded but not considered excessive Spring mounts both sides (5.3.6 (a) (i))

Rear Suspension component mounting repair covered in underseal Both sides (5.3.6 (a) (i))

Stone chip in os front headlamp glass

Underside of vehicle has heavy underseal

Nearside Rear Body has a sharp edge caused by corrosion (6.1.C.1)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Body has a sharp edge caused by corrosion (6.1.C.1)

Offside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Stop lamp not working (1.2.1b)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear Exhaust system not adequately supported (7.1.1)

Windscreen washer provides insufficient washer liquid (8.2.3)

front brake binding (3.7.B.1)

Front Brake pad(s) wearing thin (3.5.1g)

front inner flitch corrodid to excess - both sides . ( non prescribed area )