2003 Ford Ka

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement wishbone rear most bush (5.3.4 (a) (i))

Nearside Front Upper Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting sub frame to front chassis leg weak due to bad corrosion (6.2.2 (d) (i))

Rear Rear fog lamp not working (4.5.1 (a) (ii))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Nearside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Front Suspension component pin or bush slightly worn top mount bearing (5.3.4 (a) (i))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Front Suspension component pin or bush slightly worn top mount bearing (5.3.4 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Front Suspension component pin or bush slightly worn top mount bearing (5.3.4 (a) (i))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Front Suspension component pin or bush slightly worn top mount bearing (5.3.4 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Nearside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Axle swivel pins and bushes swivel pin and/or bush so worn or insecure that directional stability is impaired (5.1.2 (b) (ii)) DANGEROUS

Offside Rear Axle swivel pins and bushes swivel pin and/or bush so worn or insecure that directional stability is impaired (5.1.2 (b) (ii)) DANGEROUS

Nearside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Suspension spring mounting prescribed area is excessively corroded inner wing (2.4.A.3)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords inner tyre wall (4.1.D.1a)

Nearside Front inner wing is corroding but not holed

Nearside Rear Sub-frame attachment rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Stop lamp not working (1.2.1b)

Nearside Rear Wheel nut(s) missing (4.2.A.1e)

Offside Rear Stop lamp not working (1.2.1b)

Offside Rear Wheel nut(s) missing (4.2.A.1e)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Rear Sub-frame rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Engine warning light on.

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)