1983 Mercedes-benz 308 D

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Headlamp not working on main beam (4.1.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Headlamp not working on main beam (4.1.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps Both (4.7.1 (b) (ii))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing Outer sidewall (5.2.3 (d) (ii))

Offside Front Suspension spring mounting prescribed area is corroded but not considered excessive Anchor bracket (5.3.6 (a) (i))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Tyre slightly damaged/cracking or perishing Outer sidewall (5.2.3 (d) (ii))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Front lower step floor corroded

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Exhaust mounting defective (6.1.2 (a))

Hydraulic leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

surface corrosion underneath

Central Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Brake lever has insufficient reserve travel (1.1.2 (a))

Offside Rear Oil leaking excessively from transmission (8.4.1 (a) (i))

Rear Brake load sensing valve seized but ABS functioning (1.1.17 (c) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Central Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Dash 'bounces' on brake application - body mountings??? unable to determine.

near-side rear lamp damaged

wipers slow

Nearside Side repeater not working (1.4.A.2c)

Offside Front Brake hose ferrule excessively corroded (3.6.B.4e)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

rear brake application uneven (3.7.B.2)

rear parking (secondary) brakes imbalanced (3.7.B.6b)

Dash 'bounces' on brake application - body mountings??? unable to determine.

Headlamp aim beam image kick up to the offside both (1.8)

near-side rear lamp damaged

wipers slow

Headlamp aim beam image kick up to the offside Both (1.8)

Headlamp aim too high Both (1.8)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded Front hanger X 2 (inner & outer face of chassis leg) (2.4.A.3)

Nearside Side repeater not working (1.4.A.2c)

Offside Front Brake hose ferrule excessively corroded (3.6.B.4e)

Offside Rear Suspension spring mounting prescribed area is excessively corroded front hanger (outer face of chassis leg) (2.4.A.3)

Rear Brakes imbalanced across an axle @ 65%.... (3.7.B.5b)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Registration plate lamp not working All (1.1.C.1d)

Service brake: efficiency below requirements (3.7.B.7)

Both seatbelts slow to retract

Wiper operation slow at start!

off-side front steel brake pipe has rubbed on the chassis leg causing a mark - unable to determine depth.

off-side rear hub seal leaking

Horn not working (1.6.2a)

Nearside Front Shock absorber has a serious fluid leak (2.7.3)

Nearside Front Side repeater not working (1.4.A.2c)

Nearside Rear Brake pipe inadequately supported and fouling on axle (3.6.B.1)

Nearside Rear Rear position lamp(s) not working (1.1.A.3b)

Nearside Rear Suspension spring mounting prescribed area is fractured (2.4.A.3)

Offside Front Headlamp aim too low (1.8)

Rear Brake pipe excessively corroded FROM COMPONSATOR (3.6.B.2c)

Offside Front Leaf spring damaged but not permanently distorted (2.4.B.1a)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Front wheel bearing has slight play (2.5.A.3c)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

slight play both front kin pins

Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)

Offside Front Anti-roll bar linkage rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front wheel bearing has slight play (2.5.A.3c)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

slight play both front kin pins

Horn not working (1.6.2a)

Offside Front Passenger's seat insecure (6.2.A.1)

Windscreen washer provides insufficient washer liquid (8.2.3)

Brake load sensing valve seized (3.6.E.3)

Brakes imbalanced across an axle (3.7.B.5b)

rear brake application uneven (3.7.B.2)

Brake pipe slightly corroded (3.6.B.2c)

offside front brake disc corroded and pitted

offside rear inner wheel arch corroded

Emissions not tested (7.0)

Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust system not adequately supported (7.1.1)

Horn not working (1.6.2a)

Nearside Front Side repeater not working (1.4.A.2c)

Offside Front Side repeater not working (1.4.A.2c)

Offside Headlamp has a product on the light source so that the light output is severely reduced (1.7.5a)

Registration plate lamp not working (1.1.C.1d)

Suspension component mounting prescribed area is deliberately modified which significantly reduces the original strength (2.4.A.3)

Stop lamp not working (1.2.1b) DANGEROUS

rear brake compersator siezed

Exhaust has a minor leak of exhaust gases (7.1.2)

Exhaust has part of the system slightly deteriorated (7.1.1a)

Oil leak

Propshaft component defective

Exhaust has a minor leak of exhaust gases (7.1.2)

Exhaust has part of the system slightly deteriorated (7.1.1a)

Front Axle king pin has slight play in pin and/or bush (2.5.A.3a)

front both sides kingpins have slight play

Indicator switch faulty (1.4.A.1)

Nearside Headlamp aim beam image kick up to the offside (1.8)

Offside Headlamp aim beam image kick up to the offside (1.8)

Service brake: efficiency below requirements (3.7.B.7)

Indicator switch faulty (1.4.A.1)

Nearside Headlamp aim too low (1.8)

Nearside front brake application uneven (3.7.B.2)

Offside Headlamp aim too low (1.8)

Offside Rear Tyre(s) incorrect because tyres with different structures are fitted across the same axle (4.1.A.2a)

Offside Registration plate lamp not working (1.1.5c)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b) DANGEROUS

Exhaust has a minor leak of exhaust gases (7.1.2)

Exhaust has part of the system slightly deteriorated (7.1.1a)

Front Axle king pin has slight play in pin and/or bush (2.5.A.3a)

Emissions not tested (7.0)

Front Brake pipe excessively corroded (3.6.B.2c)

Rear Exhaust has part of the system excessively deteriorated (7.1.1a)

Front Axle king pin has slight play in pin and/or bush (2.5.A.3a)

Oil leak

Propshaft component defective

Nearside Registration plate lamp not working (1.1.5c)