1983 Mercedes-benz Sl

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Oil leak, but not excessive Engine oil. (8.4.1 (a) (i))

Vehicles internal headlight adjuster altered to recheck lights ()

Windscreen wiper blade defective Both front wiper blades. (3.4 (b) (i))

Fuel smell under rear of vehicle, no fluid leaks visible

Nearside Front Outer Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Outer Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Oil leak, but not excessive Multiple wet areas around engine, gearbox and rear dif case. no drips during test (8.4.1 (a) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Driver's view of the road through the swept area of the windscreen materially affected by an obstruction (3.1 (a) (ii))

Fuel cap/sealing device ineffective (6.1.3 (b) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Offside Headlamp aim too low and too far to the right. (4.1.2 (a))

Rear Upper Fuel hose leaking return hose to tank (6.1.3 (b) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear pads appear low

brake pad wear light on

both rear tyres starting to perish on outer tread and inner tread

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

both rear tyres heat cracked/perished

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

both rear tyres heat cracked/perished

both rear tyres starting to heat crack on outter walls

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

both rear tyres starting to heat crack on outter walls