2000 Mazda MX-5

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Brake pipe corroded, covered in grease or other material all brake pipes on under side (1.1.11 (c))

Front Service brake binding but not excessively both (1.2.1 (f))

Nearside Seat belt anchorage prescribed area is corroded but not considered excessive sill (7.1.1 (a) (i))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Outer Seat belt anchorage prescribed area is corroded but not considered excessive sill (7.1.1 (a) (i))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Outer Seat belt anchorage prescribed area is corroded but not considered excessive sill (7.1.1 (a) (i))

underside of car thick coating off underseal

Lower vehicle has excessive underseal on suspension and chassie preventing good inspection of some components

Suspension arm corroded but not seriously weakened all front+rear arms/wishbones (5.3.3 (b) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Front Service brake excessively binding (1.2.1 (f))

Rear Service brake binding but not excessively (1.2.1 (f))

Suspension arm corroded but not seriously weakened all front+rear arms/wishbones (5.3.3 (b) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Exhaust Lambda reading after 2nd fast idle outside specified limits LAMBDA HIGHT AND ENGINE TEMP CLOSE TO OVERHEATING (8.2.1.2 (c))

Nearside Rear Outer Seat belt anchorage prescribed area strength or continuity significantly reduced SILL HOLED (7.1.1 (a) (i))

Offside Headlamp aim too high (4.1.2 (a))

Power steering pipe(s) or hose(s) leaking (2.3.3b)

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Stop lamp not working (1.2.1b)

Rear Brake pad(s) wearing thin (3.5.1g)

brake disc slightly pitted (3.5.1h)

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

brake disc slightly pitted (3.5.1h)

Rear Brake pad(s) wearing thin (3.5.1g)