1983 Land Rover Series 3

Brake pedal has insufficient reserve travel (1.1.2 (a))

Front Brakes imbalanced across an axle Axle 1 (1.2.1 (b) (i))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Service brake efficiency less than 50% of the required value (1.2.2 (a) (ii)) DANGEROUS

Offside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Horn not working (7.7 (a))

Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Front Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected (5.3.6 (a) (ii)) DANGEROUS

Offside Front Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected (5.3.6 (a) (ii)) DANGEROUS

Both front metal brake pipes in op

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Suspension spring mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Brake pipe corroded, covered in grease or other material rear axle , n/s/f , front to rear (1.1.11 (c))

Fluid leak, but not excessive (8.4.1 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Suspension component mounting prescribed area is inadequately repaired (5.3.6 (a) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

offside front brake binding on slightly

oil leak from engine

Oil leak ()

Nearside Front Body or chassis has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front position lamp(s) not working (1.1.A.3b)

Windscreen washer provides insufficient washer liquid (8.2.3)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Shock absorber has a slightly worn bush (2.7.4)

Nearside Front Axle swivel joint has slight play (2.5.A.3b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

corrosion outside of perscribed areas

o/s/front tyre perishing and has cracking in tread grooves

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Axle swivel joint has slight play (2.5.A.3b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

corrosion outside of perscribed areas

Drag link end ball joint has excessive play (2.2.B.1f)

Hazard warning lamps not flashing in phase, with ignition off (1.4.B.1f)

Hazard warning lamps not flashing in phase, with ignition on (1.4.B.1f)

Brakes imbalanced across an axle (3.7.B.5b) DANGEROUS

Nearside Front front brake binding (3.7.B.1) DANGEROUS

Nearside Front Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear fog lamp not working (1.3.2b)

some corrosion to O/S/F chassis