1989 Mercedes-benz S-class

Exhaust emissions - engine idle speed too high (8.2.1.2 (e))

Nearside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch within 30cm of suspension mounting (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch area within 30cm of suspension mounting (5.3.6 (a) (i))

Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch within 30cm of suspension mounting (5.3.6 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Fuel Pipe/s corroded at rear ()

Offside Front Service brake binding but not excessively (1.2.1 (f))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Emissions not tested Engine speed to high (8.2.1.2 (d))

Central Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Seat belt anchorage prescribed area is corroded but not considered excessive Outer cill (7.1.1 (a) (i))

Offside Seat belt anchorage prescribed area is corroded but not considered excessive Outer cill (7.1.1 (a) (i))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Brake pipe slightly corroded (3.6.B.2c)

Nearside Headlamp aim too low (1.8)

Offside Front Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Front Tyre fouling a part of the vehicle (4.1.D.2)

Offside Headlamp aim too low (1.8)

offside exhaust system mounting missing but system still supported .

Brake pipe slightly corroded (3.6.B.2c)

Offside Front Exhaust has a minor leak of exhaust gases (7.1.2)

offside exhaust system mounting missing but system still supported .

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

front brake application uneven (3.7.B.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

osf tyre slighty perished

osr tyre perished

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Front Headlamp aim too high (1.8)

Offside Front Headlamp aim too high (1.8)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

osf tyre slighty perished

osr tyre perished

Tyre worn close to the legal limit (4.1.E.1)

Driver's seat cannot be secured in the upright position. (6.2.A.2)

Horn not working (1.6.2a)

Rear Rear fog lamp not working (1.3.2b)

Rear fog lamp tell tale not working (1.3.1b)

Brake pipe slightly corroded (3.6.B.2c)

Front Tyre worn close to the legal limit (4.1.E.1)

Exhaust has part of the system slightly deteriorated (7.1.1a)

both front inner arches rusty

fuel pipes corroded

nearside rear tyre wearing on edges

oil leak

slight play in steering box

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Emissions not tested (7.0)

Nearside Front Seat belt affected by an insecure seat fixing (5.2.1b)

Offside Front Seat belt affected by an insecure seat fixing (5.2.1b)

Offside Headlamp aim too low when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Exhaust has part of the system slightly deteriorated (7.1.1a)

Steering system has slight free play detected at steering wheel (2.2.A.1a)

fuel pipes corroded

nearside rear tyre wearing on inner edge

oil leak

surface rust on inner arches