1983 Ford Capri

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Oil leak

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

corrosion under wheel arch but not structural

exhaust front pipe to middle clamp reqs turning lowest point of car+middle section rubbers minor perishing+tail pipe joint minor leak

front+rear brake imbalance just within limits

rear hatch both hyd.struts worn

rear susp.bump stops missing

Nearside Front coil spring corroded (2.4.C.1b)

Nearside Rear Shock absorber has slight corrosion to the casing (2.7.2a)

Nearside Steering pivot point has slight play (2.2.B.1g)

Offside Front coil spring corroded (2.4.C.1b)

Offside Rear Shock absorber has slight corrosion to the casing (2.7.2a)

Offside Steering pivot point has slight play (2.2.B.1g)

driver seat mechanism is developing play

Nearside Headlamp aim too high (1.8)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Headlamp aim too high (1.8)

Offside Registration plate lamp not working (1.1.C.1d)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front coil spring corroded (2.4.C.1b)

Nearside Rear Shock absorber has slight corrosion to the casing (2.7.2a)

Nearside Steering pivot point has slight play (2.2.B.1g)

Offside Front coil spring corroded (2.4.C.1b)

Offside Rear Shock absorber has slight corrosion to the casing (2.7.2a)

Offside Steering pivot point has slight play (2.2.B.1g)

driver seat mechanism is developing play

Offside Rear rear brake binding (3.7.B.1)

Windscreen washer provides insufficient washer liquid (8.2.3)

Exhaust has a major leak of exhaust gases (7.1.2)

Offside Registration plate lamp not working (1.1.C.1d)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

both front dip beams slightly blurred

drivers door top hinge mount corroded and holed

n/s rear suspension bump stop rubber missing

rear wiper rubber split

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Steering rack insecure (2.2.B.1a)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

both front dip beams slightly blurred

drivers door top hinge mount corroded and holed

n/s rear suspension bump stop rubber missing

rear wiper rubber split

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Tie bar/rod rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

o/s/f wheel bearing rough