1984 Lancia Beta

Offside Front lower ball joint thread is rubbing cv boot

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Nearside Front Lower Seat belt anchorage prescribed area is excessively corroded floor (5.2.6)

Nearside Front Outer Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings by rear fog light area (6.1.B.2)

Offside Front Lower Seat belt anchorage prescribed area is excessively corroded floor (5.2.6)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Service brake: efficiency below requirements (3.7.B.7)

Steering column will not lock in a fixed position (adjustable type) (2.1.2a)

Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front lower ball joint thread is rubbing cv boot

Nearside Front Anti-roll bar linkage ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Front anti roll bar pivot has slight play

Brake pipe inadequately supported brake pipe is on rear exhaust system (3.6.B.1)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Main beam 'tell-tale' not working (1.7.4c)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Steering rack gaiter insecure (2.2.D.2d)

Nearside front brake binding (3.7.B.1)

Offside Front Lower Suspension arm has excessive play in a ball joint whilst in shaker plates (2.4.G.2)

Offside Registration plate lamp not working (1.1.C.1d)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Front Anti-roll bar linkage ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Front anti roll bar pivot has slight play

Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Lower Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Lower Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Lower Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Lower Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Stop lamp not working (1.2.1b)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Stop lamp not working (1.2.1b)

Offside rear brake recording little or no effort (3.7.B.5a)

Parking brake: efficiency below requirements (3.7.B.7)

Front Vehicle structure has slight corrosion crossmember (6.1.A.1)

Nearside Rear Tie bar/rod rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Tie bar/rod rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)