1989 Toyota MR2

Tail lights tinted but not affecting output of light

Exhaust noisy (7.1.4)

Rear lights tinted but not affecting the light out put.

Windscreen has damage to an area less than a 40mm circle outside zone 'A' small chip (8.3.1d)

Oil leak

Under-trays fitted obscuring some underside components

Vehicle clearly modified for track use

Wheels Close to inner arches on full lock

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Nearside Front Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Offside Front Direction indicator not working (1.4.A.2c)

Rear Registration plate lamp not working (1.1.C.1d)

Rear Stop lamp not working (1.2.1b)

Offside Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Oil leak

Under-trays fitted obscuring some underside components

Vehicle clearly modified for track use

Wheels Close to inner arches on full lock

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Exhaust has a major leak of exhaust gases (7.1.2)

Front position lamp(s) has less than 50% of the light sources illuminating (1.1.A.3b)

Horn not working (1.6.2a)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front position lamp(s) incorrect colour (1.1.A.3e)

Offside Headlamp aim too low (1.8)

Offside Rear Wheel nut(s) missing (4.2.A.1e)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Rear position lamp(s) has a product on the lens so it is not visible from a reasonable distance (1.1.A.3d)

Registration plate lamp not working (1.1.C.1d)

Steering wheel retaining device insecure (2.1.6)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Exhaust has a minor leak of exhaust gases (7.1.2)

Exhaust has part of the system slightly deteriorated (7.1.1a)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Driver's seat insecure (6.2.A.1)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front position lamp(s) incorrect colour (1.1.A.3e)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear fog lamp not working (1.3.2b)

Rear fog lamp tell tale not working (1.3.1b)

Oil leak

X2 FRONT TYRES CUT BUT UNABLE TO SEE CORDS

handbrake travel slightly high

oil leak

rear pads getting low

slight play in both front drop links

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Parking brake: efficiency below requirements (3.7.B.7)

Position lamp switch faulty (1.1.A.1)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front Shock absorber has a light misting of oil (2.7.3)

Front registration plate missing (6.3.1a)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Registration plate lamp not working (1.1.5c)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Parking brake: efficiency below requirements (3.7.B.7)

Position lamp switch insecure (1.1.A.1)

Rear registration plate character(s) incorrectly spaced (6.3.4a)