1992 Toyota MR2

Fuel Pipe/s corroded ()

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Front Upper Anti-roll bar linkage insecurely attached (5.3.3 (a) (i))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Offside Front Upper Anti-roll bar linkage insecurely attached (5.3.3 (a) (i))

Offside Headlamp aim too low (4.1.2 (a))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Fuel Pipe/s corroded ()

Nearside Front Brake pipe clips or supports missing, pipe adequately supported (1.1.11 (d) (i))

Offside Front Brake pipe clips or supports missing, pipe adequately supported (1.1.11 (d) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Fuel Pipe/s corroded ()

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Brake pipe excessively corroded (1.1.11 (c))

Nearside Rear Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Sub-frame corroded and seriously weakened (5.3.3 (b) (i))

Fuel Pipe/s corroded ()

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Body has slight corrosion (6.1.B.2)

Body has slight corrosion (6.1.B.2)

Brake pipe slightly corroded (3.6.B.2c)

Exhaust has a minor leak of exhaust gases (7.1.2)

Exhaust noisy (7.1.4)

Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Inner Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Body has slight corrosion (6.1.B.2)

Oil leak

Rear Suspension arm synthetic bush deteriorated but not resulting in excessive movement (2.4.G.2)

brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

rear exhaust box slightly deterioated

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Horn not working (1.6.2a)

Nearside Front An item not tested (Manual)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside front brake binding (3.7.B.1)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

front brake application uneven (3.7.B.2)

rear brake application uneven (3.7.B.2)

Brakes imbalanced across an axle (3.7.B.5b) DANGEROUS

Nearside Rear Rear wheel bearing has slight play (2.6.2)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Vehicle structure has slight corrosion (6.1.A.1)

brake disc slightly pitted (3.5.1h)