1983 Porsche 911

Emissions not tested idle speed to high (8.2.1.2 (d))

Front Registration plate missing (0.1 (a))

Front Windscreen washer not working (3.5 (a))

Horn not working (7.7 (a) (ii))

Nearside Front Headlamp aim too low (4.1.2 (a))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor by D shape bush (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Boot lid cannot be secured in the closed position (6.2.1 (e))

Rear Registration plate does not conform to the specified requirements (0.1 (d))

Rear fog lamp tell-tale not working (4.9.1 (a) (ii))

Steering wheel has excessive movement up and down (2.2.2 (a))

All direction indicators flashing more than 120 times a minute (4.4.4 (a))

Both rear tyre's starting to wear centre of tread's and cracking.

Engine and gearbox oil leaks.

Exhaust has a minor leak of exhaust gases Rear small crack (6.1.2 (a))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside rear inner road rim has been repaired.

Offside front floor drain hole plug fallen out.

Offside front tyre starting to wear inner marker.nearside front tyre lightly wearing inner edge.both tyre's cracking.

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Horn not working (1.6.2a)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Front Headlamp not working on main beam (1.7.5a)

Nearside Front Mechanical brake component has restricted free movement (3.5.1k)

Nearside Front Wheel bolt(s) missing (4.2.A.1e)

Offside Front Headlamp not working on main beam (1.7.5a)

Offside Front Mechanical brake component has restricted free movement (3.5.1k)

Offside Inner Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Rear fog lamp not working (1.3.2b)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Wheel bolt(s) missing (4.2.A.1e)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)