2004 Daihatsu Terios

Exhaust emissions exceed manufacturer's specified limit Limit 1.05 (8.2.2.2 (a))

Headlamp aim too low Both (4.1.2 (a))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Oil leaking excessively from engine (8.4.1 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps both (4.7.1 (b) (ii))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Inner Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Both rear tyres wearing on edge

Front both lower suspension arm rear bushs worn

Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Tyre worn on edge

Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Rear Coil spring corroded both (5.3.1 (b) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Suspension component corroded but not seriously weakened (5.3.3 (b) (i))

vehicle hard plated and heavy underseal

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear suspension has corrosion

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Nearside Rear Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Nearside Rear Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Front Registration plate missing (0.1 (a))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively damaged significantly reducing structural strength (5.3.6 (a) (i))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Nearside Rear Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Nearside Rear Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Seat belt anchorage prescribed area is corroded but not considered excessive (7.1.1 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Oil leak, but not excessive engine (8.4.1 (a) (i))

Rear Tyre worn close to legal limit/worn on edge both side tires, inner edges (5.2.3 (e))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced axle surface corrosion (6.1.1 (c) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Suspension arm pin or bush worn but not resulting in excessive movement both side (5.3.4 (a) (i))

Integral body structure is deformed but structural rigidity is not significantly reduced all around (6.1.1 (a) (i))

Towbar component corroded, but not excessively (6.1.6 (a))

Vehicle structure is repaired but structural rigidity is not significantly reduced

Emissions unable to be completed (8.2.1.2 (d))

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Exhaust system insecure (6.1.2 (a))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Inner Seat belt anchorage prescribed area strength or continuity significantly reduced arch/sill (7.1.1 (a) (i))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Towbar component corroded, but not excessively (6.1.6 (a))

Vehicle structure is repaired but structural rigidity is not significantly reduced (6.1.1 (d) (i))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Exhaust has a minor leak of exhaust gases requires attention (6.1.2 (a))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Towbar component corroded, but not excessively (6.1.6 (a))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis (5.3.6 (a) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Exhaust has a minor leak of exhaust gases requires attention (6.1.2 (a))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Towbar component corroded, but not excessively (6.1.6 (a))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Suspension component mounting prescribed area is corroded but not considered excessive chassis (5.3.6 (a) (i))

Towbar component corroded, but not excessively (6.1.6 (a))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

chassis will require attention

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Suspension component mounting prescribed area is corroded but not considered excessive chassis (5.3.6 (a) (i))

towbar corroded

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge on the limit (5.2.3 (e))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Brake pad(s) wearing thin (3.5.1g)

Front Tyre tread depth below requirements of 1.6mm both (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components

Engine covers fitted obscuring some components in the engine bay

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Under-trays fitted obscuring some underside components

Offside Vehicle structure has slight corrosion (6.1.A.1)

Rear wiper blade split.

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components

Offside front tyre wearing on inside edge

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside front tyre wearing on inside edge

Offside Front Tyre worn close to the legal limit (4.1.E.1)