2008 Smart (mcc) Fortwo Coupe

Nearside Rear Tyre worn close to legal limit/worn on edge 2 to 3mm (5.2.3 (e))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Tyre worn close to legal limit/worn on edge 2 to 3mm (5.2.3 (e))

Front Inner Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Rear Prop shaft joint constant velocity boot no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Front Headlamp has a product on the lens but not seriously reducing light output both (4.1.4 (b))

Rear Tyre worn close to legal limit/worn on edge both (5.2.3 (e))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Lower Engine mounting bush excessively worn

Nearside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Lower Engine mounting bush excessively worn

Nearside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

full under body covers / trays fitted at time of test

rear brakes noisy / squealing

Fuel cap/sealing device ineffective seal cracked / split (6.1.3 (b) (i))

Nearside Front Position lamp light intensity significantly reduced (4.2.3 (a) (ii))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Headlamp light intensity severely reduced (4.1.4 (a))

Offside Front Position lamp light intensity significantly reduced (4.2.3 (a) (ii))

full under body covers / trays fitted at time of test

rear brakes noisy / squealing

Front front pads at 3mm limit is 1.5mm

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure large tear to inner sidewall and has chords exposed (4.1.D.1b)

Offside Front Front position lamp(s) not working offside dipped beam not working (1.1.A.3b)

Offside Front Front suspension has excessive play in a lower wishbone bearing (2.5.B.1a)

Offside Front Headlamp aim not tested (1.8.A.1c)

Front front pads at 3mm limit is 1.5mm

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front position lamp(s) not working SIDE LIGHT (1.1.A.3b)

Nearside Rear Drive shaft which forms part of the suspension coupling gaiter damaged to the extent that it no longer prevents the ingress of dirt etc CV BOOT (2.4.G.4e)

Nearside Registration plate lamp not illuminating the registration plate (1.1.C.1e)

Nearside Rear CV JOINT DRY

Tyre worn close to the legal limit (4.1.E.1)

Under-trays fitted obscuring some underside components

Headlamp has a product on the light source so that the light output is severely reduced (1.7.5a)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Tyre worn close to the legal limit (4.1.E.1)

Under-trays fitted obscuring some underside components

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front suspension has excessive movement at a wishbone pin or bush (2.5.A.1c)

Nearside Rear Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

EML ON

Centre Stop lamp not working (1.2.1b)

Nearside Stop lamp not working (1.2.1b)