2011 Mitsubishi L200

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Tyre slightly damaged/cracking or perishing Both (5.2.3 (d) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Power steering pump has slight seepage (2.1.5 (a))

Rear Tyre slightly damaged/cracking or perishing both (5.2.3 (d) (ii))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

SMALL CRACK IN N/S LOWER CORNER OF FRONT SCREEN

Brake pipe corroded, covered in grease or other material ALL BRAKE PIPES COVERED IN PAINT G,GREASE ETC (1.1.11 (c))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Front brake pad(s) appear to be wearing low

Rear universal joint has play in

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

parking brake travel has little reserve travel

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

front and rear brake pipe(s) slightly corroded

surface corrosion underside of vehicle

Central Prop shaft flexible coupling excessively deteriorated (6.1.7 (d) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

front and rear brake pipe(s) slightly corroded

surface corrosion underside of vehicle

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Prop shaft bearing housing fractured (6.1.7 (f) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Brakes imbalanced across an axle (3.7.B.5b)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Tyre has ply or cords exposed (4.1.D.1b)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

offside rear tyre has nails and cuts

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)