2009 Mitsubishi Lancer

Nearside Brake pipe corroded, covered in grease or other material front to rear at rear (1.1.11 (c))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Exhaust emissions test not completed because smoke levels are significantly in excess of the specified limit values (8.2.2.2 (f))

Nearside Brake pipe corroded, covered in grease or other material front to rear at rear (1.1.11 (c))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Brake pipe corroded, covered in grease or other material front to rear at rear (1.1.11 (c))

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Offside Brake pipe corroded, covered in grease or other material front to rear at rear (1.1.11 (c))

Offside Front Lower Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Brake pipe corroded, covered in grease or other material front to rear at rear (1.1.11 (c))

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Offside Brake pipe corroded, covered in grease or other material front to rear at rear (1.1.11 (c))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Suspension component mounting prescribed area is corroded but not considered excessive Inner sills/ends. (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive Inner sills (5.3.6 (a) (i))

Nearside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Rear Suspension component mounting prescribed area is corroded but not considered excessive Inner sills (5.3.6 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Front Registration plate does not conform to the specified requirements (0.1 (d))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Rear Registration plate does not conform to the specified requirements (0.1 (d))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Nearside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear brake binding slightly

Offside Front Brake pipe slightly corroded pipe to flexy hose (3.6.B.2c)

engine cover and under tray fitted

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

o/s/r tyre tread perished and cracking

Nearside Headlamp aim too far to the right (1.8)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

n/s/r and o/s/r tyre treads perished and cracking