2008 Mercedes-benz B-class

Front Anti-roll bar linkage ball joint dust cover severely deteriorated both sides (5.3.4 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Fuel Pipe/s corroded ()

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Fuel Pipe/s corroded ()

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Fuel Pipe/s corroded ()

Driver's seat fore and aft adjustment mechanism not functioning as intended. (6.2.5 (b) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Brake pad(s) wearing thin Both front (1.1.13 (a) (ii))

Coil spring corroded Both rear (5.3.1 (b) (i))

Fuel cap/sealing device ineffective (6.1.3 (b) (i))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Windscreen washer not working (3.5 (a))

Nearside Front Tyre tread depth below requirements of 1.6mm edges (5.2.3 (e)) DANGEROUS

Brake pad(s) wearing thin Both front (1.1.13 (a) (ii))

Coil spring corroded Both rear (5.3.1 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Fuel cap/sealing device missing (6.1.3 (b) (i))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

undertrays fitted

Nearside Front Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Oil leak

Rear Parking brake lever has little reserve travel (3.1.6b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)