2002 Nissan Almera

Child Seat fitted not allowing full inspection of adult belt ()

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive Sill (5.3.6 (a) (i))

Offside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Offside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive Sill (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Tyre slightly damaged/cracking or perishing Both (5.2.3 (d) (ii))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Rear Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Nearside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Tyre worn inner edge

Offside Rear Suspension component mounting repair covered in underseal (5.3.6 (a) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Emissions not tested due to exhaust blow (8.2.1.2 (d))

Front Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Inner Suspension component mounting prescribed area is inadequately repaired sill reAR END (5.3.6 (a) (i))

Offside Outer Suspension component mounting prescribed area is inadequately repaired SILL REAR END (5.3.6 (a) (i))

Nearside Front Inner Tyre worn close to legal limit/worn on edge edge low (5.2.3 (e))

Offside Front Inner Tyre worn close to legal limit/worn on edge edge bald (5.2.3 (e))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill rear end (5.3.6 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch in front of n/s/rear wheel (5.3.6 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill rear end (5.3.6 (a) (i))

Nearside Rear Brake hose ferrule excessively corroded and likely to fail (1.1.12 (f) (ii)) DANGEROUS

Nearside Headlamp aim too high adjusted (4.1.2 (a))

Offside Front Inner Tyre worn close to legal limit/worn on edge edge (5.2.3 (e))

Offside Front Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Rear Brake hose slightly deteriorated at ferrule corroded (1.1.12 (b) (ii))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Front engine mounting bracket insecure and likely to fail (6.1.D.1b)

front cross member corroded but not structual

Front Brake pad(s) wearing thin (3.5.1g)

Nail in offside rear tyre

both front tyres cutting out on inside edge