2003 Peugeot 206

Central Rear Seat belt not functioning as intended (7.1.2 (c))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Rear Brake load sensing valve seized but ABS functioning (1.1.17 (c) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Nearside Front Coil spring corroded (5.3.1 (b) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Central Seat belt not functioning as intended (7.1.2 (c))

Nearside Headlamp aim too high (4.1.2 (a))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Registration plate lamp insecure (4.7.1 (c) (i))

Nearside Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Registration plate lamp insecure (4.7.1 (c) (i))

Offside Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

advanced wear rear tyres

Nearside Front position lamp(s) not working (1.1.A.3b)

advanced wear rear tyres

corrosion to front coil springs

Exhaust has part of the system slightly deteriorated (7.1.1a)

Exhaust has part of the system slightly deteriorated (7.1.1a)

see advisory sheet number 690647927200

Horn not working (1.6.2a)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Exhaust has part of the system slightly deteriorated (7.1.1a)

movement in o/s steering rack

Offside Headlamp aim too high (hotspot upper edge above the horizontal 0% line) (1.6.D1)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g) DANGEROUS