2006 Kia Carens

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Emissions not tested due to condition of exhaust (8.2.1.2 (d))

Front Exhaust has a major leak of exhaust gases flexi pipe (6.1.2 (a))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Position lamp not working (4.2.1 (a))

Offside Headlamp aim too low (4.1.2 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Rear Exhaust system insecure (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

exhaust hanger broken at rear but system still adequately supported

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

exhaust hanger broken at rear but system still adequately supported

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Centre Front registration plate deteriorated (6.3.1d)

Nearside Rear Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Offside Rear rear parking brake recording little or no effort (3.7.B.6a)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Front wheel bearing rough when rotated (2.5.A.2)

Nearside Inner Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)