2006 Fiat Punto

Front Anti-roll bar corroded but not seriously weakened (5.3.3 (b) (i))

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced sills,floor pan, strut towers and inner wings front and rear (6.1.1 (c) (i))

Nearside Front Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Macpherson strut pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Suspension arm corroded but not seriously weakened axle beam (5.3.3 (b) (i))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Rear Inner Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

catalyst heat sheild loose

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Headlamp aim too high (4.1.2 (a))

Nearside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Rear Inner Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Headlamp aim too high (4.1.2 (a))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

catalyst heat sheild loose

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced outer sills (6.1.1 (c) (i))

Offside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Rear Exhaust system insecure (6.1.2 (a))

Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Headlamp aim too low (4.1.2 (a))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced outer sills (6.1.1 (c) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Integral body structure is corroded but structural rigidity is not significantly reduced strut top mounts (6.1.1 (c) (i))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Anti-roll bar pin or bush worn but not resulting in excessive movement BOTH SIDES (5.3.4 (a) (i))

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Anti-roll bar pin or bush worn but not resulting in excessive movement BOTH SIDES (5.3.4 (a) (i))

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Lower Gearbox mounting defective ()

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

SUMP PAN CORRODED & LEAKING

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced INNER & OUTER SILLS BOTH SIDES (6.1.1 (c) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Suspension component corroded but not seriously weakened BEAM AXLE (5.3.3 (b) (i))

SUMP PAN CORRODED

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Offside Front Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced INNER & OUTER SILLS BOTH SIDES (6.1.1 (c) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Suspension component corroded but not seriously weakened BEAM AXLE (5.3.3 (b) (i))

SUMP PAN CORRODED

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

EXHAUST MANIFOLD HEAT SHIELD LOOSE

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Inner Brake pipe slightly corroded (3.6.B.2c)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Front Lower Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear Inner Brake pipe slightly corroded (3.6.B.2c)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Front Brake pad(s) wearing thin (3.5.1g)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

rear bumper damaged

Exhaust has a minor leak of exhaust gases (7.1.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Direction indicator adversely affected by the operation of another lamp nearside and offside interfering with tail lights (1.4.A.2h)

Nearside Front Sub-frame corroded and seriously weakened (2.4.G.1)

Nearside Front Suspension arm rubber bush bonding deteriorated resulting in excessive movement rear (2.4.G.2)

Nearside Outer Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front Suspension arm rubber bush bonding deteriorated resulting in excessive movement rear (2.4.G.2)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Headlamp aim too low (1.8)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

engine started to overheat during emissions test

front brake pads appear low

rear coil springs corroded

slight blow from exhaust rear silencer

topped up engine oil level- 1 ltrs 5/30 semi

Exhaust front pipe bracket is corroded and broken,

Front coolant pipe is heavily corroded in front of engine block,

Rear tyres are worn down to 2.5mm on outer edges,

Sump is heavily corroded and leaking,

O/S/F SEAT BELT SLOW TO RETRACT BATTERY SECURED WITH WOODEN BLOCKS

both rear shocker upper rubber mounts poor