2007 Toyota Aygo

Exhaust mounting defective (6.1.2 (a))

advise both sill on corrsion

advise front x member /and wishbone on corrsion

Front Brake disc worn, but not excessively both sides (1.1.14 (a) (i))

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

under body light corrosion

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Tyre worn close to legal limit/worn on edge both sides (5.2.3 (e))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Rear Brakes imbalanced across an axle (1.2.1 (b) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Rear Exhaust mounting defective (6.1.2 (a))

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre not fitted in accordance with side wall instructions (4.1.D.1f)

Front Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Rear Tyre worn close to the legal limit (4.1.E.1)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Front Brake pad(s) wearing thin (3.5.1g)