2012 Ford Mondeo

Nearside Front Anti-roll bar ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Exhaust emissions test not completed because smoke levels are significantly in excess of the specified limit values (8.2.2.2 (f))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Side repeater obviously incorrectly positioned can not be seen from side (4.4.3 (a))

Offside Front Anti-roll bar ball joint excessively worn (5.3.4 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Seat belt retracting mechanism defective (7.1.2 (e))

Offside Rear Lower Suspension arm pin or bush excessively worn arm marked in yellow (5.3.4 (a) (i))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm bush (5.3.4 (a) (i))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge inner edge close to cords (5.2.3 (e))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Offside Front Tyre worn close to legal limit/worn on edge inner edge close to cords (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Shock absorbers has a reduced damping effect (5.3.2 (d))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Suspension component pin or bush slightly worn trailing arm (5.3.4 (a) (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Brake pad(s) wearing thin ON LIMIT (1.1.13 (a) (ii))

Offside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Suspension component pin or bush slightly worn trailing arm (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Front Headlamp aim too low can not be adjusted (4.1.2 (a))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b) DANGEROUS

Offside Front Tyre has ply or cords exposed (4.1.D.1b) DANGEROUS

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)