2002 Fiat Punto

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Gearbox mounting defective ()

Oil leak, but not excessive around oil pressure switch (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

slight play in steering rack

Front Exhaust has a major leak of exhaust gases down pipe (6.1.2 (a))

Nearside Rear Inner Seat belt anchorage prescribed area strength or continuity significantly reduced wheel arch (7.1.1 (a) (i))

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Rear Exhaust has a major leak of exhaust gases back box (6.1.2 (a))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Gearbox mounting defective ()

Oil leak, but not excessive around oil pressure switch (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

slight play in steering rack

Front both sides tyres wearing on edges

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Coil spring worn both sides (5.3.1 (b) (i))

corrosion mid floor both sides

slight dampness around sump

slight play in steering rack

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Rear Brake pipe slightly corroded (3.6.B.2c)

corrosion both sides mid floors

Rear Inner sills corrode

Front Tyre tread depth below requirements of 1.6mm BOTHSIDES (4.1.E.1)

Rear Inner sills corrode

Front exhaust bracket cracked

Offside Front bottom ball joint rubber split

Offside Front tyre getting low on outer shoulder

oil leak engine

front exhaust mount corroded

sump corroded

none standard rear exhaust fitted

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

none standard rear exhaust fitted

offside inner sill corroed

engine oil leak

front prake pads low

wiper blades split

floor to sill corroding o/s

rear exhaust mount perished

slight exhaust blow at rear joint

sump badly corroded

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Headlamp aim beam image kick up to the offside (1.8)

Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

slight exhaust blow at front joint

front metal exhaust bracket cracked

rear jacking points corroding

slight play offside front bottom ball joint

mid exhaust cracked

Brakes imbalanced across an axle (3.7.B.5b)

Tyre tread depth below requirements of 1.6mm (4.1.E.1)

front wipers sticking under load