2003 Ford Focus

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Rear coil spring corroded (2.4.C.1b)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

oil leak

front exhaust flexi-pipe deteriorated

o/s/f window inop

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

front exhaust flexi-pipe deteriorated

front tyres getting low on edges/3mm

o/s/f window inop

reverse lights inop

o/s/f window inop

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Rear coil spring corroded (2.4.C.1b)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear coil spring corroded (2.4.C.1b)

ns rear wheel bearing is noisy, not rough when rotated at time of inspection

Exhaust has part of the system slightly deteriorated (7.1.1a)

Front Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Front Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

front brake discs wearing thin on inner sides

Exhaust has part of the system slightly deteriorated (7.1.1a)

Front Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Front Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Headlamp aim too high and too far to the right. (1.8)

Offside Front Headlamp aim too low (1.8)

front brake discs wearing thin on inner sides

Offside Front Headlamp aim too low (1.8)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Headlamp not in good working order adversely affecting beam image (1.2.4a)