2008 Peugeot Boxer

Front Brakes imbalanced across an axle (1.2.1 (b) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner and outer sill \step (5.3.6 (a) (i))

Offside Front Service brake excessively binding (1.2.1 (f))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Service brake efficiency below requirements (1.2.2 (a) (i))

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

under side corroded

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill small hole (5.3.6 (a) (i))

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Exhaust mounting defective 2 of 4 rubber mountings split (6.1.2 (a))

Nearside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside n/s outer and inner sillin centre below sliding door badly corroded but not with 30cm of areas

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside o/s outer sill corroded in centre but not within 30cm of areas

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Lower Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Rear tyre cracked and perished.

Windscreen has damage to an area less than a 10mm circle within zone 'A' 2 chips (8.3.1a)

large crack across bottom of windscreen does not affect drivers view ok for mot.

Nearside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear tyre cracked and perished.

Windscreen has damage to an area less than a 10mm circle within zone 'A' 2 chips (8.3.1a)

large crack across bottom of windscreen does not affect drivers view ok for mot.

windscreen cracked along bottom edge

Exhaust system not adequately supported (7.1.1)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Rear fog lamp not working (1.3.2b)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Offside Headlamp aim too low (1.8)

windscreen cracked along bottom edge

Nearside Rear n/s/r tyre craked and perished to outer sidewall

Windscreen has damage to an area less than a 10mm circle within zone 'A' 3 chips (8.3.1a)

large crack across bottom of screen o/s/f does not affect drivers view

Nearside Front front brake binding (3.7.B.1)

Offside Rear Rear fog lamp not working (1.3.2b)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear n/s/r tyre craked and perished to outer sidewall

Windscreen has damage to an area less than a 10mm circle within zone 'A' 3 chips (8.3.1a)

large crack across bottom of screen o/s/f does not affect drivers view

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

exhaust box outer casing rusty

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

exhaust box outer casing rusty

Oil leak

rear exhaust box outer casing in poor condition but not blowing at time of test

Nearside Registration plate lamp not working (1.1.C.1d)

Rear Exhaust system not adequately supported (7.1.1)

Oil leak

rear exhaust box outer casing in poor condition but not blowing at time of test

Spare tyre defective

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

air bag light on dash

exhaust box outer casing corroded

intermittent abs fault light not on at test

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear Exhaust system not adequately supported (7.1.1)