2002 Ford Ka

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Rear Sub-frame pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength front of inner arch (5.3.6 (a) (i))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Inner Seat belt anchorage prescribed area strength or continuity significantly reduced sill and floor (7.1.1 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Sub-frame pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength front of inner arch (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Coolant leak ()

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive floor (5.3.6 (a) (i))

Nearside Front Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Seat belt anchorage prescribed area is corroded but not considered excessive drivers door inner pillar (7.1.1 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive floor (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch (5.3.6 (a) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced centre inner sill has two holes (7.1.1 (a) (i))

Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner arch (5.3.6 (a) (i))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced two holes within the chassis rail (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Front Steering locking device missing trackends spilt pins missing (2.2.C.1g)

Nearside Front Battery insecure (1.9.1)

Nearside Front Body or chassis has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear Rear wheel bearing rough when rotated (2.6.1)

Offside Rear Rear fog lamp missing (1.3.2a)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Offside Rear Shock absorber has a serious fluid leak (2.7.3)

Offside Rear wheel bearing rough when rotated (2.6.1)

Power steering pipe(s) or hose(s) leaking from a joint leaking from seal on rack housing (2.3.3b)

Rear rear brake recording little or no effort (3.7.B.5a)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1) DANGEROUS

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Windscreen has damage to an area in excess of a 10mm circle within zone 'A' (8.3.1a)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Shock absorber has a serious fluid leak (2.7.3)

Nearside Rear coil spring fractured (2.4.C.1a)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

adv both front chassis legs next to front subframe mountings corroded and blistered

adv corrosion around fuel filler cap

strong adv both outer sills heavily corroded and blistered

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a) DANGEROUS

adv both front chassis legs next to front subframe mountings corroded and blistered

adv corrosion around fuel filler cap

strong adv both outer sills heavily corroded and blistered

Nearside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Play in both front suspension leg top mountings

n/s/f tyre 2mm o/s/f tyre 2.5mm