2002 Ford Mondeo

Emissions unable to be completed levels too high (8.2.1.2 (d))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced floor corroded (7.1.1 (a) (i))

Brake pipe corroded, covered in grease or other material some steel (1.1.11 (c))

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced Various places (6.1.1 (c) (i))

Nearside Headlamp slightly loose

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced under side of vehicle (6.1.1 (c) (i))

Windscreen wiper blade defective (3.4 (b) (i))

Brake pipe corroded, covered in grease or other material some steel (1.1.11 (c))

Offside Front Brake hose slightly twisted (1.1.12 (b) (i))

Offside Front Seat belt webbing slightly damaged or frayed (7.1.2 (b) (ii))

Brake pipe corroded, covered in grease or other material some steel (1.1.11 (c))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Brake pipe corroded, covered in grease or other material some steel (1.1.11 (c))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Power steering component fouling pipe hitting drive shaft (2.1.5 (e) (i))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

light corrosion on body

Offside Front Seat belt stitching slightly frayed (5.2.2b)

Sub-frame rubber bush deteriorated but not resulting in excessive movement all rear (2.4.G.2)

Rear Bonded suspension unit deteriorated but can function as intended (2.4.F.3)

Offside Front coil spring broken (2.4.C.1a)

Rear Bonded suspension unit deteriorated but can function as intended (2.4.F.3)

Bonded suspension unit deteriorated but can function as intended (2.4.F.3)

Brake pipe slightly corroded (3.6.B.2c)

Nearside Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

near/side rear tyre cracking

Rear Brake pipe slightly corroded (3.6.B.2c)

cracks in n/s rear tyre

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Rear Brake pipe slightly corroded (3.6.B.2c)

cracks in n/s rear tyre

Exhaust has part of the system slightly deteriorated (7.1.1a)

Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

both front tyres are worn on edges of tread

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)