2008 Toyota Prius

Front Tyre worn close to legal limit/worn on edge both (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake disc worn, pitted or scored, but not seriously weakened both (1.1.14 (a) (ii))

Rear Headlamp has a product on the lens but not seriously reducing light output both (4.1.4 (b))

Rear Shock absorbers has a reduced damping effect both (5.3.2 (d))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Vehicle has general underbody corrosion

Front Headlamp has a product on the lens but not seriously reducing light output both (4.1.4 (b))

Fuel Pipe/s corroded ()

general underbody rust

Front Headlamp has a product on the lens but not seriously reducing light output both (4.1.4 (b))

Fuel Pipe/s corroded ()

Vehicle has general corrosion underneath

Rear Fuel Pipe/s corroded ()

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Registration plate does not conform to the specified requirements (0.1 (d))

Nearside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Rear Fuel Pipe/s corroded ()

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

rear end getting flaky + rusty slightly

Windscreen wiper does not clear the windscreen effectively both front (8.2.2)

Front Inner Brake pad(s) wearing thin worn (3.5.1g)

rear end getting flaky + rusty slightly

both front tyres warn outter edges

Front Brakes imbalanced across an axle (3.7.B.5b)

both front tyres warn outter edges

exhaust heat shield adrift rear

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)