2013 Toyota Aygo

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Front Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Inner Steering rack has excessive free play detected at the steering wheel (steering rack fitted) rack joint (2.3 (a) (i))

Nearside Headlamp aim unable to be tested (4.1.2 (b))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Headlamp not working on main beam (4.1.1 (a) (ii))

Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Front Bumper insecure (6.1.4 (a) (i))

Offside Front Direction indicator incorrect colour (4.4.3 (a))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Headlamp aim too low (4.1.2 (a))

Nearside Front Inner Brake disc in such a condition that it is seriously weakened (1.1.14 (a) (ii)) DANGEROUS

Nearside Rear Inner Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Offside Front Inner Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened both (1.1.14 (a) (ii))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Lower Suspension arm pin or bush excessively worn front bush (5.3.4 (a) (i))

Offside Front Brake valve insecure bolt missing (1.1.7 (c))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Front Headlamp levelling device inoperative (4.1.5 (a))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened both (1.1.14 (a) (ii))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Battery insecure and likely to cause a short circuit (4.13 (a) (ii))

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Exhaust emissions hydrocarbon content excessive (8.2.1.2 (b))

Front Brakes imbalanced across an axle (1.2.1 (b) (i))

Horn not working (7.7 (a))

Nearside Front Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Front Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Front Direction indicator not working (4.4.1 (a) (ii))

Offside Front Headlamp aim unable to be tested (4.1.2 (b))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Anti-roll bar linkage fractured (5.3.3 (b) (ii)) DANGEROUS

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Ball joint has excessive play (2.2.B.1f)

Offside Ball joint has excessive play (2.2.B.1f)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)