2015 Qingqi Qm

Brake lever is short but brake can still be readily applied (1.1.2 (d))

Chain guard missing

Headlamp light intensity reduced (4.1.4 (a))

Nearside Front Shock absorber has a light misting of oil (5.3.2 (b))

Offside Front Shock absorber has a light misting of oil (5.3.2 (b))

Rear Suspension pin, bush or joint worn but not resulting in excessive movement (5.3.4 (a) (i))

Steering headbearing slightly stiff or notchy (2.2.2 (f) (i))

Chain guard missing

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Headlamp lens slightly defective (4.1.1 (b) (i))

Headlamp light intensity reduced (4.1.4 (a))

Nearside Rear grab rail loose o/s/r grab rail missing

Offside Front Brake lever is short but brake can still be readily applied (1.1.2 (d))

Rear Brake indicates slight fluctuation of brake effort (1.2.1 (e))

Rear Suspension pin, bush or joint worn but not resulting in excessive movement (5.3.4 (a) (i))

Steering headbearing slightly stiff or notchy (2.2.2 (f) (i))

no rear pegs fitted off roader

various panels zip tied to secure

Front Brake grabbing severely (1.2.1 (c))

Nearside Front Lower Shock absorber has a serious fluid leak (5.3.2 (b))

Rear Drive chain worn to excess (6.1.7 (c) (i))

Front Brake pad(s) less than 1.0 mm thick (1.1.13 (a)) DANGEROUS

Rear Wheel bearing play so excessive it is likely to break up (5.1.3 (a) (ii)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Wheel has a slightly distorted bead rim (5.2.2 (c) (i))

Front Wheel spoke slightly loose (5.2.2 (d))

Rear Shock absorber has a slightly worn bush (5.3.2 (c))

Headlamp aim too low (4.1.2 (a))

Front Wheel has a slightly distorted bead rim (5.2.2 (c) (i))

Front Wheel spoke slightly loose (5.2.2 (d))

Rear Shock absorber has a slightly worn bush (5.3.2 (c))

Chain guard insecure (6.1.7 (i))

Drive chain excessively tight (6.1.7 (k) (i))

Front Brake pad(s) contaminated (1.1.13 (b))

Nearside Front Shock absorber has a serious fluid leak (5.3.2 (b))

Rear Wheel spoke missing (5.2.2 (d))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Brake indicates slight fluctuation of brake effort (1.2.1 (e))

Front Brake pad(s) close to minimum limit (1.1.13 (a))

Front Wheel has a slightly distorted bead rim (5.2.2 (c) (i))

Rear Brake indicates slight fluctuation of brake effort (1.2.1 (e))

Rear Brake pad(s) close to minimum limit (1.1.13 (a))

Rear Shock absorber has a slightly worn bush (5.3.2 (c))

Steering headbearing slightly stiff or notchy (2.2.2 (f) (i))

Wheel alignment slightly misaligned (2.4 (a))

oil leak on engine

Drive chain slightly tight (6.1.7 (k) (i))

Rear Brake indicates slight fluctuation of brake effort (1.2.1 (e))

Rear Suspension pin, bush or joint worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Wheel spoke slightly loose some spokes slightly loose (5.2.2 (d))

Steering headbearing slightly stiff or notchy (2.2.2 (f) (i))

Drive chain worn but not considered excessive (6.1.7 (c) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Steering headbearing slightly stiff or notchy (2.2.2 (f) (i))

Wheel alignment slightly misaligned (2.4 (a))

Headlamp aim too low (4.1.2 (a))

Drive chain horseshoe locking device incorrectly fitted (6.1.7 (j) (i))

Rear Brake master cylinder insecure (1.1.10 (c))

Rear reflector defective or damaged by more than 50% of the reflecting surface covered up (4.8.1 (a) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Steering headbearing slightly stiff or notchy (2.2.2 (f) (i))

Wheel alignment slightly misaligned (2.4 (a))

Drive chain slightly loose (6.2.1d)

Nearside Rear grab rail broken

Rear Roller brake test indicates slight fluctuation of brake effort (3.3.A1d)