2002 Fiat Punto

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Front Brakes imbalanced across an axle (3.7.B.5b)

Front Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Nearside Front Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front Suspension has inadequate clearance with the chassis (2.4.A.1a)

Nearside Headlamp aim too high (1.8)

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear coil spring corroded so that its cross sectional area is reduced and seriously weakened (2.4.C.1b)

Offside Front Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear coil spring corroded so that its cross sectional area is reduced and seriously weakened (2.4.C.1b)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1) DANGEROUS

Coolant leak

Cooling fan not working

Oil leak

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Rear Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Suspension arm corroded but not seriously weakened (2.4.G.1)

Body has a sharp edge caused by damage (6.1.C.1)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Offside Rear Brake hose ferrule excessively corroded (3.6.B.4e)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Suspension arm corroded but not seriously weakened (2.4.G.1)

Exhaust system not adequately supported (7.1.1)

Headlamp aim too high (1.8)

CHECK COOLANT FAN OPERATION

Front Brake pad(s) wearing thin (3.5.1g)

NOISE TOP SUSPENSION MOUTINS SPRINGS TWANGING

SLIGHT DAMAGE O/S/R

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Front Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Nearside Front coil spring incomplete (2.4.C.1a)

Offside Front coil spring incomplete (2.4.C.1a)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Offside Headlamp not in good working order but not adversely affecting beam image (1.2.4a)

Offside Rear coil spring corroded (2.4.C.1b)

Horn not working (1.6.2a)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside rear tyre low, 2mm, wearing uneven, outer edge, limit 1.6mm.

Rear exhaust mounting splitting, recommend replace.

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)