2006 Ldv Maxus

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill to rear (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill to front (5.3.6 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Brake pipe corroded, covered in grease or other material both front to rear covered in underseal (1.1.11 (c))

Nearside Front Brake pipe corroded, covered in grease or other material to flexi (1.1.11 (c))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Brake pipe corroded, covered in grease or other material to flexi (1.1.11 (c))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Nearside Rear Service brake lagging in operation (1.2.1 (d))

Brake pipe corroded, covered in grease or other material both front to rear covered in underseal (1.1.11 (c))

Nearside Front Brake pipe corroded, covered in grease or other material to flexi (1.1.11 (c))

Nearside Headlamp aim too high (4.1.2 (a))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Brake pipe corroded, covered in grease or other material to flexi (1.1.11 (c))

Offside Headlamp aim too high (4.1.2 (a))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front to rear brake pipe covered in under seal.

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front to rear brake pipe covered in under seal.

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Oil sweat at sump.

Brake pipe corroded, covered in grease or other material All pipes covered with grease. (1.1.11 (c))

Exhaust emissions exceed level of metered smoke for a turbo charged engine Limit is 3.00, the average reading achieved is 3.61. (8.2.2.2 (b))

Nearside Rear Brake pipe excessively corroded Pipe across rear axle. (1.1.11 (c))

Offside Front Position lamp not working (4.2.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Rear wheel bearing has excessive play (2.6.2)

Brake pipe slightly corroded 2x pipes at rear flexi hoses (3.6.B.2c)

Parking brake lever has little reserve travel (3.1.6b)

Brake pipe slightly corroded 2x pipes at rear flexi hoses (3.6.B.2c)

Offside Rear fog lamp not working (1.3.2b)

Parking brake lever has little reserve travel (3.1.6b)

Parking brake lever has little reserve travel (3.1.6b)

Nearside Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Front constant velocity joint gaiter damaged, but preventing the ingress of dirt (2.5.C.1a)

Nearside Rear wheel bearing has slight play (2.6.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

middle rear folding seat, seatbelt insecure

rear folding seat, seatbelt insecure

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Rear wheel bearing has slight play (2.6.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

middle rear folding seat, seatbelt insecure

rear folding seat, seatbelt insecure

Nearside Rear Rear wheel bearing has slight play (2.6.2)

Offside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

wiring cable tied to exhaust and spare wheel carrier

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Headlamp aim too high (1.8)

Nearside Rear Rear wheel bearing has slight play (2.6.2)

Offside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

wiring cable tied to exhaust and spare wheel carrier

Parking brake: efficiency below requirements (3.7.B.7)

Rear fog lamp not working (1.3.2b)

Rear fog lamp switch faulty (1.3.1a)

Brake hydraulic reservoir fluid close to minimum level (3.6.G.1b)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Offside Front Seat belt damaged but webbing not significantly weakened (5.2.2a)

Centre Vehicle structure has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)