2003 Peugeot 206

Rear Brake load sensing valve stiff (1.1.17 (c) (ii))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Rear Brake load sensing valve stiff (1.1.17 (c) (ii))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Power steering component(s) has slight seepage from a component steering rack (2.3.3b)

Brake valve has an excessive discharge of oil (load sensing valve) (3.6.E.1)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (floor panel) (6.1.B.2)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Rear Rear fog lamp not working (1.3.2b)

Service brake: efficiency below requirements (3.7.B.7)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Offside Rear Hydraulic brake cylinder leaking hydraulic fluid (3.6.A.1) DANGEROUS

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Power steering component(s) has slight seepage from a component steering rack (2.3.3b)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Direction indicator incorrect colour (1.4.A.2f)

Nearside Stop lamp not working (1.2.1b)

Offside Front position lamp(s) not working (1.1.A.3b)

Registration plate lamp not working (1.1.C.1d)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear fog lamp not working (1.3.2b)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Oil leak

Nearside Front Seat belt damaged but webbing not significantly weakened (5.2.2a)

Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Seat belt damaged but webbing not significantly weakened (5.2.2a)

Nearside Stop lamp not working (1.2.1b)

Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Seat belt damaged but webbing not significantly weakened (5.2.2a)

Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Side repeater incorrect colour (1.4.A.2f)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

both front brake discs excessivly worn

slight brake drag to n/s/f wheel

brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Brake load sensing valve linkage seized (3.6.E.3)

Nearside rear brake recording little or no effort (3.7.B.5a)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

dipstick end snapped off, possibly in sump

n/s/f wishbone arm rear bush splitting

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)