2003 Fiat Punto

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Central Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Shock absorbers has slight external damage to the casing (5.3.2 (b))

Offside Front Lower Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Shock absorbers has slight external damage to the casing (5.3.2 (b))

Central Bonnet primary retaining device ineffective (3.1 (c))

Central Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Nearside Front Shock absorbers has slight external damage to the casing (5.3.2 (b))

Offside Front Lower Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Shock absorbers has slight external damage to the casing (5.3.2 (b))

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Suspension component mounting prescribed area is excessively corroded inner wheel arch (2.4.A.3)

Offside Rear Shock absorber has a serious fluid leak (2.7.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded inner wheel arch (2.4.A.3)

front brake excessively fluctuating both front (3.7.B.3)

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

brake disc worn, pitted or scored, but not seriously weakened both front (3.5.1i)

Shock absorber has slight corrosion to the casing both rears (2.7.2a)

Sub-frame corroded but not seriously weakened (2.4.G.1)

Suspension component mounting prescribed area is corroded but not considered excessive both rear outer sills (2.4.A.3)

coil spring corroded both rears (2.4.C.1b)

Nearside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Shock absorber has slight corrosion to the casing both rears (2.7.2a)

Sub-frame corroded but not seriously weakened (2.4.G.1)

Suspension component mounting prescribed area is corroded but not considered excessive both rear outer sills (2.4.A.3)

coil spring corroded both rears (2.4.C.1b)

Sub-frame corroded but not seriously weakened (2.4.G.1)

coil spring corroded both rear (2.4.C.1b)

rear requirements only just met. It would appear that the braking system requires adjustment or repair.

Headlamp aim too low (1.8)

Offside Front coil spring broken (2.4.C.1a)

Windscreen wiper not operating automatically when switched on (8.2.1b)

Sub-frame corroded but not seriously weakened (2.4.G.1)

car overheating whilst caring out test

coil spring corroded both rear (2.4.C.1b)

rear requirements only just met. It would appear that the braking system requires adjustment or repair.

Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Suspension arm rubber bush bonding deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Direction indicator not working (1.4.A.2c)

Offside Front Suspension arm rubber bush bonding deteriorated resulting in excessive movement (2.4.G.2)

Offside Headlamp aim too low (1.8)

Offside Front Direction indicator not working (1.4.A.2c)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Track rod end ball joint has slight play (2.2.B.1f)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Track rod end ball joint has slight play (2.2.B.1f)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Rear registration plate obscured (6.3.1d)