2007 Volkswagen Beetle

Electronic stability control warning lamp indicates a fault (7.12 (e))

Emissions unable to be completed (8.2.1.2 (d))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Front Registration plate insecure (0.1 (a))

Offside Front Service brake excessively binding (1.2.1 (f))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Service brake excessively binding (1.2.1 (f))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Coil spring corroded nearside and offside (5.3.1 (b) (i))

Rear Service brake binding but not excessively nearside and offside (1.2.1 (f))

Brake fluid contaminated (1.8 (a))

Drive belt excessively worn (6.1.7 (c) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Front Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt nearside and offside (2.1.3 (g) (ii))

Offside Front Inner Suspension rod pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Offside Front Service brake binding but not excessively (1.2.1 (f))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Coil spring corroded nearside and offside (5.3.1 (b) (i))

Rear Service brake binding but not excessively nearside and offside (1.2.1 (f))

Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt nearside and offside (2.1.3 (g) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing cracking between treads (5.2.3 (d) (ii))

Rear Coil spring corroded nearside and offside (5.3.1 (b) (i))

Exhaust has a minor leak of exhaust gases rear joint (6.1.2 (a))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Headlamp aim too high (1.8)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Engine covers fitted obscuring some components in the engine bay

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nail in nearside rear tyre

items over 40mm hanging in windscreen are MOT fail