2007 Ford Focus

Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Inner Tyre worn close to legal limit/worn on edge edge (5.2.3 (e))

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Inner Tyre worn close to legal limit/worn on edge edge (5.2.3 (e))

Offside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Rear Exhaust mounting defective (6.1.2 (a))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Outer Integral body structure is corroded but structural rigidity is not significantly reduced wing (6.1.1 (c) (i))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Outer Integral body structure is corroded but structural rigidity is not significantly reduced wing (6.1.1 (c) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Outer Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Offside Rear Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Exhaust mounting defective (6.1.2 (a))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Front Suspension component ball joint dust cover severely deteriorated Nearside & Offside bottom ball joint (5.3.4 (b) (i))

Front Suspension component ball joint dust cover severely deteriorated Nearside & Offside bottom ball joint (5.3.4 (b) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

o/s rear tyer worn on outer edge

Nearside Front Headlamp aim too low (1.8)

o/s rear tyer worn on outer edge

Nearside Front Lower Suspension arm ball joint dust cover damaged, but preventing the ingress of dirt wishbone (2.4.G.2)

Rear Tyre worn close to the legal limit both (4.1.E.1)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Rear Tyre worn close to the legal limit both (4.1.E.1)

Nearside Front suspension has excessive movement at a wishbone pin or bush (2.5.A.1c)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front suspension has excessive movement at a wishbone pin or bush (2.5.A.1c)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Front Tyre worn close to the legal limit (4.1.E.1)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

rear tyres slightly perished

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

rear tyres slightly perished

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)