2008 Ford C-max

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated Slight leakage of grease (6.1.7 (g) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Power steering component has slight seepage from a component Steering rack area (2.1.5 (a))

Centre exhaust heatshield is loose

Nearside Front Tyre worn close to legal limit/worn on edge Tyre is wearing slightly on the inner edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge Tyre is wearing slightly on the inner edge (5.2.3 (e))

Power steering component has slight seepage from a component Steering rack area (2.1.5 (a))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Headlamp aim too high (4.1.2 (a))

Offside Headlamp aim too high (4.1.2 (a))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Offside Front Lower Suspension arm ball joint likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm rubber bush bonding deteriorated resulting in excessive movement (2.4.G.2)

Rear Stop lamp not working (1.2.1b)

Tyre tread depth below requirements of 1.6mm FRONT X2 (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Steering rack gaiter split (2.2.D.2d)

Front Tyre tread depth below requirements of 1.6mm x2 (4.1.E.1)

Nearside Headlamp not working on dipped beam (1.7.5a)