2009 Seat Leon

Exhaust emits black smoke during acceleration (8.2.1.2 (g))

Front Drive shaft joint constant velocity boot severely deteriorated both side (6.1.7 (g) (i))

Front Windscreen stone chip in it

General under body corroded

Offside Front Anti-roll bar ball joint has slight play (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Suspension arm corroded but not seriously weakened both side (5.3.3 (b) (i))

Rear Suspension arm pin or bush worn but not resulting in excessive movement both side (5.3.4 (a) (i))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre has ply or cords exposed (5.2.3 (d) (ii)) DANGEROUS

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Rear Tyre slightly damaged/cracking or perishing CRACKING (5.2.3 (d) (ii))

Offside Headlamp aim too low (4.1.2 (a))

Driver's airbag obviously inoperative (7.1.5 (c))

Nearside Front signs of slight cracking in trad area

Offside Front slight cracking in tread area

Offside Rear inner edge signs of castaling may cause road noise

Nearside Rear Shock absorber has a serious fluid leak (2.7.3)

Offside Rear Shock absorber has a serious fluid leak (2.7.3)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)