2001 Ford Mondeo

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Nearside Front Anti-roll bar ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Macpherson strut has excessive movement in the upper support bearing assembly (2.5.B.1b)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Headlamp has a product on the lens so that the light output is severely reduced (1.7.5a)

Offside Outer Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Nearside Rear Sub-frame rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside Rear Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Offside Rear Sub-frame rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Parking brake lever has little reserve travel (3.1.6b)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

o/s/r tyre has sut in side wall

Nearside Front Lower Anti-roll bar ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Rear position lamp(s) has light sources not illuminating, but not more than 50% (1.1.A.3b)

Rear Parking brake lever ratchet mechanism is slightly worn (3.1.5)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside rear brake binding (3.7.B.1)

Parking brake: efficiency below requirements (3.7.B.7)

Offside rear parking brake recording little or no effort (3.7.B.6a) DANGEROUS

Nearside Front Lower Anti-roll bar ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Front Lower Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Rear position lamp(s) has light sources not illuminating, but not more than 50% (1.1.A.3b)

Offside Front Macpherson strut has slight movement in the upper support bearing assembly (2.5.B.1b)

Offside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Rear Sub-frame rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Rear Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Child seat fitted not allowing full inspection of adult belt

Offside Front Tyre worn close to the legal limit (4.1.E.1)

engine management light on

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Rear Road wheel bead rim badly distorted (4.2.A.1a)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Rear rear brake juddering slightly (3.7.A.5b)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear subframe mounting bushes seperating