2001 Land Rover Freelander

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Tyre worn close to legal limit/worn on edge both (5.2.3 (e))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Tyre worn close to legal limit/worn on edge both (5.2.3 (e))

Nearside Front Position lamp not working (4.2.1 (a))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

oil leak

exhaust system corroded and deteriorated

Towbar component slightly corroded (6.6.1)

brake pipes slightly corroded

fuel tank retaining device slightly corroded

rear tyres 2-2.5mm tread depth

Offside Front coil spring corroded (2.4.C.1b)

Rear Brake pipe slightly corroded (3.6.B.2c)

advice rear boot handle insecure

advice rear differential support mount deteriorated

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Oil leak

Rear Shock absorber has a slightly reduced damping effect (2.7.5)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Track rod end ball joint has excessive play (2.2.B.1f)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Oil leak

Rear Shock absorber has a slightly reduced damping effect (2.7.5)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Stop lamp excessively damaged so that it is not visible from a reasonable distance (1.2.1d)

Nearside Rear Stop lamp not working (1.2.1b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Parking brake: efficiency below requirements (3.7.C.1b)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Centre Rear Upper Stop lamp not working (1.2.1b)

Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Parking brake: efficiency below requirements (3.7.C.1b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

advice nearside rear door check strap insecure

Front Brake pad(s) wearing thin (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)