2008 Ford Ka

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced Floor corroded and holed (7.1.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill corroded and holed (5.3.6 (a) (i))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Chassis box section above exhaust back box (6.1.1 (c) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced Floor corroded and holed (7.1.1 (a) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Seat belt anchorage prescribed area is corroded but not considered excessive Outer sill corroded (7.1.1 (a) (i))

Power steering pipe/hose slightly corroded By gearbox (2.1.5 (g) (i))

Seat belt anchorage prescribed area is corroded but not considered excessive inner sill corrosion both sides (7.1.1 (a) (i))

Nearside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim too low and too far to the left. (1.8)

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Offside front brake juddering severely (3.7.A.2b)

Nearside front brake juddering slightly (3.7.A.2b)