2012 Toyota Aygo

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Emissions unable to be completed (8.2.1.2 (d))

Front Brake pad(s) contaminated both sides (1.1.13 (b))

Horn not working (7.7 (a))

Nearside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Nearside Rear Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced sill holed (6.1.1 (c) (i))

Front Oil leak, but not excessive at gear box (8.4.1 (a) (i))

Nearside Front Direction indicator slightly discoloured (4.4.3 (a))

Nearside Front Outer grease on cv boot

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Wheel bearing slightly noisy and slight play (5.1.3 (b) (i))

Nearside Front Direction indicator slightly discoloured (4.4.3 (a))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Emissions unable to be completed Leaking from rear section (8.2.1.2 (d))

Nearside Front Direction indicator slightly discoloured (4.4.3 (a))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Non obligatory rear view camera insecure and hanging down on wire.

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Front Anti-roll bar pin or bush worn but not resulting in excessive movement n/s/f and o/s/f (5.3.4 (a) (i))

Rear Brake pipe corroded, covered in grease or other material n/s/r and o/s/r (1.1.11 (c))

Rear Exhaust has a minor leak of exhaust gases box corroded (6.1.2 (a))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Outer Brake pad(s) wearing thin (3.5.1g)

Offside Front Outer Brake pad(s) wearing thin (3.5.1g)