2004 Fiat Stilo

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Direction indicator incorrect colour (4.4.3 (a))

Offside Rear Position lamp adversely affected by the operation of another lamp (4.2.3 (c))

Offside Rear Stop lamp(s) adversely affected by the operation of another lamp (4.3.3 (b))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Registration plate insecure but not likely to fall off broken on screw fittings (0.1 (a))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Exhaust system insecure back box clamp loose (6.1.2 (a))

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Offside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Rear Parking (secondary brake) on a single line braking system has inadequate effort at a wheel (1.3.1 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Front Exhaust has a major leak of exhaust gases front to middle section on gasket (6.1.2 (a))

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced outer sill (6.1.1 (c) (i))

Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced outer sill (6.1.1 (c) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Lower Body has slight corrosion outer sill (6.1.B.2)

Offside Lower Body has slight corrosion outer sill (6.1.B.2)

Central Front registration plate deteriorated (6.3.1d)

Nearside Front Headlamp aim too low (1.8)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Lower Body has slight corrosion outer sill (6.1.B.2)

Offside Lower Body has slight corrosion outer sill (6.1.B.2)

Nearside Rear Bonded suspension unit bonding failed and part of unit is likely to become displaced (2.4.F.2)

Offside Rear Bonded suspension unit bonding failed and part of unit is likely to become displaced (2.4.F.2)

Nearside Front Anti-roll bar ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Front Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Nearside Front Brake pipe inadequately clipped (3.6.B.1)

Nearside Front Lower Suspension arm rubber bush bonding deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Offside Front Lower Suspension arm rubber bush bonding deteriorated resulting in excessive movement (2.4.G.2)

Nearside Outer Front Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)