2003 Ford Focus

Main beam tell-tale not working (4.9.1 (a) (ii))

Offside Headlamp aim projected beam image is obviously incorrect no pattern (4.1.2 (c))

Coolant leak ()

Nearside Front Tyre worn close to legal limit/worn on edge and smooth on edges (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge and smooth on edges (5.2.3 (e))

all brake discs very rusty

all rear suspension very rust & corroding including subframe

n/s/r wheel rim small dent

rust patches in various places

Central Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Front Lower Suspension arm pin or bush excessively worn inner front bush . (5.3.4 (a) (i))

Nearside Rear Outer Seat belt anchorage prescribed area strength or continuity significantly reduced Lower body sill corroded. (7.1.1 (a) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Central Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Outer Suspension arm attachment bracket/mounting corroded but its strength is not seriously reduced outer body sill corroded (5.3.3 (b) (i))

Nearside Windscreen wiper blade defective (3.4 (b) (i))

Offside Windscreen wiper blade defective (3.4 (b) (i))

Front Tyre worn close to legal limit/worn on edge both sides (5.2.3 (e))

Nearside Front Inner Road wheel slightly distorted (5.2.2 (c) (i))

Nearside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Headlamp aim not tested (4.1.2 (b))

Headlamp aim projected beam image is obviously incorrect both sides (4.1.2 (c))

Nearside Rear Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Rear Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Front Tyre worn close to legal limit/worn on edge both sides (5.2.3 (e))

Nearside Front Inner Road wheel slightly distorted (5.2.2 (c) (i))

Nearside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Nearside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Headlamp aim so that beam "kick up" is not visible on the screen kick up to right (4.1.2 (a))

Nearside Headlamp aim too low bulb incorectley fitted (4.1.2 (a))

Offside Front Position lamp not working (4.2.1 (a))

Offside Headlamp aim so that beam "kick up" is not visible on the screen kick up to right (4.1.2 (a))

rear brake pipe slightly corroded

Rear Brake pipe slightly corroded both (3.6.B.2c)

Nearside Rear Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Rear Brake pipe slightly corroded both (3.6.B.2c)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Seat belt flexible stalk damaged but not likely to lead to failure under load (5.2.4a)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

offside windscreen washer jet partially blocked

rear exhaust heat shield insecure

Engine management light on.

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Stop lamp not working (1.2.1b)

Rear Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Engine management light on.

Front Tyre worn close to the legal limit (4.1.E.1)

Nail in offside rear tyre

Nail in offside rear tyre

Nearside Rear Road wheel slightly damaged (4.2.A.1a)

Power steering pump has slight seepage from a component (2.3.3b)

Nearside Rear Road wheel with a slightly distorted bead rim (4.2.A.1a)

Nearside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre has ply or cords exposed (4.1.D.1b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front and rear brake discs rusty and pitted.

Nearside Front Headlamp not working on dipped beam (1.7.5a)

Nearside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Nearside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

O/S/F tyre perished.

Offside Front Headlamp not working on dipped beam (1.7.5a)

Offside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Road wheel bead rim badly distorted (4.2.A.1a)