2003 Ford Ka

Brake master cylinder/servo mounting prescribed area is excessively corroded (1.1.21 (e) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Offside Rear Position lamp adversely affected by the operation of another lamp (4.2.3 (c))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced front & rear floorpans (7.1.1 (a) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Rear fog lamp not working (4.5.1 (a) (ii))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Rear Nail in tyre ()

Rear Exhaust mounting defective (6.1.2 (a))

eml on

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor pan (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor pan (5.3.6 (a) (i))

Offside Stop lamp(s) adversely affected by the operation of another lamp (4.3.3 (b))

Nearside Front Inner Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Rear Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

corrosion front & rear

n/s rear tyre perishing

Emissions not tested because of exhaust (7.3.A.1)

Exhaust has a major leak of exhaust gases (7.1.2)

Fuel tank leaking (7.2.3)

Nearside Front front brake excessively fluctuating (3.7.B.3)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Rear Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

corrosion front & rear

n/s rear tyre perishing

Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front front brake fluctuating, but not excessively (3.7.B.3)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

corrosion on underside

oil leak

Front registration plate deteriorated (6.3.1d)

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure inside edge (4.1.D.1b)

Nearside Stop lamp not working (1.2.1b)

Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front front brake fluctuating, but not excessively (3.7.B.3)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

corrosion on underside

oil leak

Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Oil leak

Rear Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Nearside Steering rack gaiter split (2.2.D.2d)

Offside Front Lower Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Rear Trailing arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Oil leak

Rear Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Stop lamp not working (1.2.1b)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Vehicle structure has slight corrosion (6.1.A.1)

Nearside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Tyre has ply or cords exposed (4.1.D.1b)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Vehicle structure has slight corrosion (6.1.A.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)