2004 MG ZS

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Front Service brake excessively fluctuating (1.2.1 (e))

Horn not working (7.7 (a) (ii))

Nearside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch (5.3.6 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch (5.3.6 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Brakes imbalanced across an axle (3.7.B.5b)

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components

underbody corrosion in various places

Nearside Headlamp not working on dipped beam (1.7.5a)

Engine covers fitted obscuring some components in the engine bay

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Under-trays fitted obscuring some underside components

underbody corrosion in various places

Engine covers fitted obscuring some components in the engine bay

underbody corrosion in various places(plastic sill covers fitted)

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

bad cut in n/s rear tyre inner curbing bar

wear on inner shoulder of n/s front tyre

wear on inner shoulder of o/s rear tyre

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Rear position lamp(s) not working (1.1.A.3b)

Offside Stop lamp not working (1.2.1b)

Exhaust has part of the system slightly deteriorated (7.1.1a)

rear brakes are sticking slightly

rear tyres are worn on inside part of tread

both front tyres are worn on inside part of tread.