2013 Peugeot 208

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement Lower arm rear bush (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement Lower arm rear bush (5.3.4 (a) (i))

Rear Exhaust mounting defective Rear Tailpipe mountings deteriorated (6.1.2 (a))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive Both sides (5.3.6 (a) (i))

Nearside Direction indicator not working (4.4.1 (a) (ii))

Offside Rear Service brake excessively binding (1.2.1 (f))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement Lower arm rear bush (5.3.4 (a) (i))

Offside Front Service brake binding but not excessively Tight spot (1.2.1 (f))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement Lower arm rear bush (5.3.4 (a) (i))

Rear Exhaust mounting defective Rear Tailpipe mountings deteriorated (6.1.2 (a))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive Both sides (5.3.6 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear brake binding on manual check

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Rear brake binding on manual check

Exhaust Lambda reading after 2nd fast idle outside specified limits 1.045 (8.2.1.2 (c))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp aim too low (4.1.2 (a))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Vehicles internal headlight adjuster altered to recheck lights 2 to 0 ()

exhaust brackets / mounts modified

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Exhaust mounting defective (6.1.2 (a))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Front Exhaust emissions likely to be affected by an exhaust leak (8.2.2.1 (b))

Nearside Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Windscreen washer not working (3.5 (a))

Nearside Rear Stop lamp not working (1.2.1b)