2003 Ford Focus

Nearside Front Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Nearside Inner Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security SILL TOWARDS THE REAR (6.2.2 (d) (i))

Offside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Front Brake pipe corroded, covered in grease or other material from servo (1.1.11 (c))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Horn not working (7.7 (a))

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Brake pipe corroded, covered in grease or other material FRONT TO REAR (1.1.11 (c))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Offside Front Upper Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Headlamp aim projected beam image is obviously incorrect x 2 dip beam (4.1.2 (c))

Headlamp aim too high x 2 main beam (4.1.2 (a))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Headlamp aim projected beam image is obviously incorrect both (4.1.2 (c))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Headlamp aim too low (1.8)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front coil spring broken (2.4.C.1a)

Offside Headlamp aim too high (1.8)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Headlamp aim too low (1.8)

Nearside Outer Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Headlamp aim too high (1.8)

Rear fog lamp not working (1.3.2b)

Nearside Front Track rod end ball joint has excessive play (2.2.B.1f)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Stop lamp adversely affected by the operation of another lamp (1.2.1f)

Front Exhaust system not adequately supported (7.1.1)

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Front Track rod end ball joint has excessive play (2.2.B.1f)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp aim aimed so that it dazzles other road users (1.8.A.1a)