2006 Peugeot 107

Front Anti-roll bar pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Front Headlamp has a product on the lens but not seriously reducing light output both sides (4.1.4 (b))

Rear Coil spring worn both sides (5.3.1 (b) (i))

Rear Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Vehicle structure slightly corroded within 30cm of towbar mounting front & rear (6.1.6 (i) (i))

Front Brake disc significantly and obviously worn both sides (1.1.14 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Service brake efficiency below requirements (1.2.2 (a) (i))

Front Brake pad(s) less than 1.5 mm thick both sides (1.1.13 (a) (ii)) DANGEROUS

Front Inner Tyre has a tear, caused by separation or partial failure of its structure both sides edges (5.2.3 (d) (ii)) DANGEROUS

Front Anti-roll bar pin or bush worn but not resulting in excessive movement both sides (5.3.4 (a) (i))

Front Headlamp has a product on the lens but not seriously reducing light output both sides (4.1.4 (b))

Rear Coil spring worn both sides (5.3.1 (b) (i))

Rear Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Vehicle structure slightly corroded within 30cm of towbar mounting front & rear (6.1.6 (i) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Coil spring corroded both sides (5.3.1 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Rear Lower Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Offside Rear Lower Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Coil spring corroded both sides (5.3.1 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Central Brake lever pivot excessively tight (1.1.1 (a))

Emissions NOx sensor obviously modified (8.2.1.1 (a))

Front Brakes imbalanced across an axle Axle 1 (1.2.1 (b) (i))

Front Headlamp aim projected beam image is obviously incorrect both sides (4.1.2 (c))

Front Position lamp not working both sides (4.2.1 (a) (ii))

Front Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen both sides (3.5 (a))

Nearside Rear Hydraulic brake cylinder leaking hydraulic fluid (1.1.16 (b) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Rear Exhaust emissions likely to be affected by an exhaust leak by rear box (8.2.2.1 (b))

Front Brake pad(s) less than 1.5 mm thick both sides (1.1.13 (a) (ii)) DANGEROUS

Front Tyre tread depth below requirements of 1.6mm both sides (5.2.3 (e)) DANGEROUS

Nearside Rear Stop lamp(s) all not working (4.3.1 (a) (iii)) DANGEROUS

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Front Coil spring corroded (5.3.1 (b) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Rear Coil spring corroded (5.3.1 (b) (i))

Rear Shock absorbers has slight external damage to the casing (5.3.2 (b))

Rear axle corroded

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Brake pipe corroded, covered in grease or other material Main feed brake pipe (1.1.11 (c))

Offside Rear Brake pipe excessively corroded Main feed brake pipe (1.1.11 (c))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Brake pipe corroded, covered in grease or other material Main feed brake pipe (1.1.11 (c))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Headlamp aim too high (1.8)

Rear Tyre worn close to the legal limit (4.1.E.1)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust has a major leak of exhaust gases (7.1.2)

Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front wheel bearing rough when rotated (2.5.A.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Brake pipe slightly corroded (3.6.B.2c)

Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Brakes imbalanced across an axle (3.7.B.5b)